PAN1026 change baud rate

Is it possible to change the baud rate? I use M2_BTL_SET_BAUDRATE exactly as specified, get the correct event response, then wait 100ms. But if I set it to anything other than 115200, it does not respond further.

2replies Oldest first
  • Oldest first
  • Newest first
  • Active threads
  • Popular
  • Issue the M2_BTL_SET_BAUDRATE command in HCI mode.

    Check the HCI M2 SET return event for errors.

    A delay of 100ms is recommended in the specification to give the PAN1026 time to switch. In that time the host controller needs to reconfigure the baudrate to the desired baudrate as well.

    After the delay, the communication can be continued with the new baudrate.

    No special handling is necessary afterwards.

  • Rich Trueman 


    Is it possible to change the default Baudrate?

Like Follow
  • Status Answered
  • 1 yr agoLast active
  • 2Replies
  • 1002Views
  • 6 Following